Banner D10 Series Manuel d'utilisateur télécharger pdf (Page 3)

Static TEACH and Manual Adjust. Using Manual Adjust with Static TEACH moves the switching threshold. The lighted LED on the bar

graph will move to exhibit the received signal, relative to the switchpoint.

Bar Graph LED Following TEACH Relative Signal Difference / Recommendation

6 to 8 Excellent: Very stable operation

4 to 5 Good: Minor sensing variables may affect sensing reliability

2 to 3 Low: Minor sensing variables may affect sensing reliability

1 Unreliable: Consider an alternate sensing scheme

Push Button

0.04 seconds < "Click" < 0.8 sec-

onds

Remote Line

0.04 seconds < T < 0.8 seconds

Result

Access TEACH

Mode

• Press and hold Static button > 2

seconds

• No action required; sensor is ready

for 1st TEACH condition

Power LED: OFF

Output LED: ON

Status LEDs: LO & DO alternately flashing

Bar graph: OFF

TEACH Output

ON Condition

• Present Output ON condition

• Click Static button

• Present Output ON condition.

• Single-pulse remote line

Power LED: OFF

Output LED: Flash, then OFF

Status LEDs: LO & DO alternately flashing

Bar graph: OFF

TEACH Output

OFF Condition

• Present Output OFF condition

• Click Static button

• Present Output OFF condition.

• Single-pulse remote line

TEACH Accepted

Power LED: ON

Bar graph: One LED flashes to show

relative contrast (good signal difference shown;

see table above)

Sensor returns to Run mode

TEACH Unacceptable

Power LED: OFF

Bar graph: #1, 3, 5, 7 alternately flash

to show failure

Sensor returns to "TEACH Output ON condition"

D10 Expert Series with Bar Graph Display and Discrete Output

P/N 117830 Rev. F www.bannerengineering.com - tel: 763-544-3164 3

1 2 3 4 5 6 7 8 ... 12 13

Commentaires sur ces manuels

Pas de commentaire

Banner D10 Series Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Banner D10 Series