Banner MINI-BEAM2 QS12 Series Manuel d'utilisateur télécharger pdf (Page 5)

P/N 59040 rev. B

MINI-BEAM

2 QS12 Series

Miniature Photoelectric Sensors

Banner Engineering Corp.

•

Minneapolis, MN U.S.A.

www.bannerengineering.com • Tel: 763.544.3164

Supply Voltage

10 to 30V dc (10% maximum ripple) at less than 25 mA, exclusive of load

Supply Protection Circuitry

Protected against reverse polarity and transient voltages

Output Configuration

Solid state complementary (SPDT): NPN or PNP (current sinking or sourcing) output models available

Output Rating

150 mA maximum each output at 25°C

OFF-state leakage current:

less than 10 µA @ 30V dc

ON-state saturation voltage:

less than 1V @ 10 mA; less than 2.0V @ 150 mA

Output Protection Circuitry

Protected against false pulse on power-up and continuous overload or short circuit of outputs

Output Response

Opposed Mode:

8 milliseconds ON, 4 milliseconds OFF

All others:

1.5 milliseconds

NOTE: 500 millisecond delay on power-up, outputs do not conduct during this time

Repeatability

Opposed Mode:

1 millisecond

All others:

175 microseconds

Adjustments

One rubber-sealed push button

Hold:

Maximum gain

Click:

Reduce gain one increment

Indicators

2 LEDs, visible from back and sides of sensor: 1 green, 1 amber

Green steady:

Power ON

Yellow steady:

Light sensed

Green flashing rapidly 5 times:

Maximum gain

Single Green flash:

Click registered, gain reduced by one increment (total of 8)

Yellow/Green alternating:

Minimum gain (can not reduce further)

Construction

Black polycarbonate/ABS alloy housing; totally encapsulated circuitry

Environmental Rating

IEC IP67; NEMA 6

Connections

2 m (6.5’) 4-wire PVC cable, 9 m (30’) PVC cable, or 4-pin Pico-style 150 mm (6”) pigtail QD

Operating Conditions

Temperature:

-20° to +55° C (-4° to +131° F)

Relative Humidity:

90% @ 50° C (non-condensing)

Certifications

Specifications

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Banner MINI-BEAM2 QS12 Series Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Banner MINI-BEAM2 QS12 Series