Banner PresencePLUS P4 EDGE 1.3 Series Manuel d'utilisateur télécharger pdf (Page 37)

Tools Screen

5.1 Overview

Using the Tools screen, the user establishes the inspections that the Sensor will execute. Three

sources of inspections are available:

1. Building an inspection from scratch is the typical method of establishing an inspection. The Tools screen

is designed to aid the user in building an inspection. A typical inspection consists of Location Tools, followed

by Vision Tools, Analysis Tools, and finally (if required) the Communication Tool. The Tools screen, shown

below, supports this inspection organization.

2. Existing inspections can be obtained from the sensor (with or without the reference image) for execution

or modification. This method is very useful if the user has an existing inspection on the controller and needs

to make modifications to establish a new inspection.

3. Existing inspections also can be obtained from host resources using the Library. In this case, the sources

of the inspections are the host’s hard drive or network resources. This method provides access to an

unlimited number of existing inspections (with or without the reference image) for execution or modification.

37Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com

Tel: 763.544.3164

P/N 000000

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 257 258

Pas de commentaire

Banner PresencePLUS P4 EDGE 1.3 Series Manuel d'utilisateur Page 37